Welcome, Guest. Please login or register.

Show Posts

This section allows you to view all posts made by this member. Note that you can only see posts made in areas you currently have access to.


Topics - SgtCornMuffin

Pages: [1]
1
Discovery / SNMP - Juniper routing instance
« on: September 04, 2019, 09:35:50 AM »
Hello!

Recently our juniper EX series switches have moved over to a different ISP provider requiring us to set up an "routing-instance" in our switches for the layer 3 traffic forwarding.

This means that the default root routing isnt at a play when speaking to our server LAN and therefore don't have access to our NeDi client.
On our loopback interface we have an MGMT-IP wich is connected to the routing-instance from wich nedi will pull SNMP from, the only change in NeDi is the added IP-Adresses in netfilter and the adding of the vlan in the community config, like before it was public, but now it is 100-Data@Public where 100-Data is the routing-instance.


I get the MiB information from the switches but in NeDi only the Vlans and Loopback interfaces shows up and i cant see LLDP neighbours.

This also leads to a rather unpleasant 100-Data@SYS-SW01 name.

Has anyone experienced this before and can tell me if the problem is in the NeDi config och the SNMP config on the equipment?

I would suspect that there is both work needing to be done to connect default/root routing to the routing-instance in regards of the LLDP function, but as for "system name" i dont know if it's possible to configure it to not display the name of the routing-instance from the equipment or if it can be "hacked" away from NeDi Conf.

And if you cant tell im quite new to NeDi, much applies!


2
Discovery / Dicovery - Netfilter error.
« on: July 02, 2019, 02:12:12 PM »
Hello !

This is my first post as a member of this forum.
I'm a freshly graduated IT-Operations technician with my focus in networking and surveillance.

We are switching over the a different ISP provider and have a new network configured.

When i add this network to the Seedlist along with the new community i get following error when running nedi.pl. (with the entire range ofcourse)

Could someone point me in the right direction here? SNMPwalk work's just fine.




Pages: [1]