Topics

1

Discovery / RX/TX Data from SFP-Modules (C9500-48Y4C)

« on: October 27, 2022, 03:59:32 pm »

We are trying to get RX/TX-Data from SFP-Modules into nedi. They are reported fine at the CLI and /var/nedi/nedi.pl -v -SGg -a"XXX.XXX.XXX.XXX" shows them as expected - but writes "no module" to the end of every line. In the Devices Status only the default values (-100dbm) are displayed:

Code: [Select]

Use of uninitialized value in exists at /var/nedi/inc/libsnmp.pm line 5355.
OPT :1263 Twe1/0/25 RX -6 (no module)
Use of uninitialized value in exists at /var/nedi/inc/libsnmp.pm line 5355.
OPT :1118 Twe1/0/1 TX -23 (no module)


Code: [Select]

TwentyFi1/0/25 RX:-100dBm TX: -100dBm SFP-10G-LRM
Nedi version is 2.1.071 and the extended def-file is attached. Did we miss anything?

2

Discovery / CDPD link changed on discovery

« on: June 21, 2019, 11:56:04 am »

We have some ports with GXP2160 IP phones. These are detected by CDP and the description is set according: CDP:GXP2160_xx:xx:xx:xx:xx:xx

Some users seem to turn off the device outside working hours (power strip?) and nedi sends annoying discovery messages ("...was CDPD link changed type  from CDPD" or "...is CDPD link changed type  to CDPD"). Is there a way to skip this messages for these devices or selected ports?

Thanks!