NeDi Community

Networking => General Topics => Topic started by: menerson on January 21, 2015, 05:46:08 AM

Title: Use bits/sec instead of bytes/sec?
Post by: menerson on January 21, 2015, 05:46:08 AM
I got my Nedi install up an running on Ubuntu and Nedi 1.0.9.  Is there a way to switch the RRD graphs to show in bits/sec?  I vaguely remember answering a question during install about bits or bytes, but that could have been another program I was testing.  I did a lot of searching and couldn't find out how to change it.  I even looked back at MRTG to see if I could figure this out.

Any help would be great
Title: Re: Use bits/sec instead of bytes/sec?
Post by: rickli on January 25, 2015, 02:23:14 AM
I was hoping a community member would answer this...but before you give up, it's in User-Profile on the right (Monitor section). Check the box next to the blue triangle...